Yamaha CDR-D651 Mode D'emploi page 18

......................................................RECORDING FUNCTIONS
All track synchronized recording
This mode is convenient for recording all of the material
from a single audio source such as an MD, cassette tape,
or LP. Track markers are automatically placed between the
tracks being recorded.
1-5.
Repeat the steps described in the previous
section "Single track synchronized recording".
6.
Press REC MODE twice.
ALL and SYNCHRO indicators light in the display.
2 1:41
ALL SYNCHRO
7.
Start playing the source.
• This unit automatically starts recording.
• When making a digital recording, a new track
marker is placed each time a new track begins on
the source component.
• When making an analog recording, spaces of
silence are interpreted as track separations, and a
new track marker is placed when a new audio
signal is detected. The silence should be about 4
seconds long.
8.
Once this unit has recorded 20 seconds of
continuous silence, recording ends and "Wait"
lights in the display while the disc information is
being written to the PMA.
After this writing is complete, this unit enters the stop
mode.
When all recording is complete, perform finalization. (See
page 21 for the finalization procedure.)
Notes
• Track numbers may not be correctly recorded depending on the
source component. In this case, perform track marking
manually.
• If the recording source has excessive noise or contains a lot of
low level sound, track marking may not be properly performed
without the silence being recognized. In this case, perform track
marking manually.
• If the sampling frequency changes while making digital
recordings from an external unit, this unit may fail to perform
synchronized recording normally.
CD–R
REC
44.I
L
dB –60 –30 –I0 –6 –4 –2 –I 0 OVER
R
Full AUTO synchronized recording with
finalization
This mode automatically performs finalization after all
synchronized recording is complete.
(See page 21 for the finalization procedure.)
1-5.
Repeat the steps described in the section
"Single track synchronized recording".
6.
Press REC MODE three times.
AUTO and SYNCHRO indicators light in the display.
2 1:41
SYNCHRO
7.
Start playing the source.
This unit automatically starts recording.
8.
Once this unit has recorded 20 seconds of
continuous silence, recording ends and "Wait"
lights in the display while the disc information is
being written to the PMA.
9.
Finalization automatically starts after this writing
is complete.
• Press a to cancel finalization before the 20 seconds
of continuous silence is reached.
• Once finalization is started, operation buttons do not
work.
• Never turn off the power during finalization.
• Recording stops while the source is being played if
there is no more recordable space on a disc, or 99
tracks have been already recorded. In this case,
perform finalization manually.
Note
• When making a synchronized recording after DISC A is selected
using INPUT, track marking and ending are all performed based
on the CD placed on disc tray A. Also recording can be done at
double speed if necessary by changing the copy speed in the
menu settings when DISC A is selected.
CD–R REC
44.I
AUTO L
dB –60 –30 –I0 –6 –4 –2 –I 0 OVER
R
E-
17