SOLIS BARISTA PERFETTA PLUS 1170 Mode D'emploi page 31

6. Refill the water tank with minimum 40.6 fl oz of tap water. Empty both contain-
ers and the drip tray. Replace the drip tray and grid. Place the two containers
back under the brewing head resp. under the steam/hot water wand.
7. Press the steam button, approx. 33.8 fl oz of water will run through the brewing
group without a pause. During this rinsing process, open the steam/hot water
control once to the maximum position for minimum 20 seconds so that the
steam/hot water wand is also rinsed. Then, turn the steam/hot water control
back to the OFF position so that the remaining water runs through the brewing
group. During the rinsing process, the Prog. button and the steam button flash
quickly again.
8. When the rinsing process is complete, both coffee buttons light up white again,
the other buttons are not lit up and a signal sounds twice.
9. Remove the water tank again, empty it out, rinse it with clear water and reinsert
the water filter. Empty the drip tray and rinse it.
NOTE: Please wipe potential splashes of descaling solution on the appliance casing
away immediately, as the agent might damage the surface.
NOTE: If the descaling procedure is not completed correctly (e.g. no electricity), we
recommend to complete the procedure and rinse properly the appliance.
WARNING: Never submerge power cord, power plug or the appliance itself
in water or any other liquid. During descaling, never remove the water tank
or allow it to empty completely.
s
T H E ALA RM S IG NA LS
ATTENTION! In general: If a button flashes red, it represents an alarm signal!
NOTE: The appliance remains operational and coffee can still be dispensed. Only the
settings are unavailable while an alarm is emitted.
WA TE R FILT E R H A S T O B E RE P L A CE D :
■
BUTTON FL A S HE S WHIT E / R E D
For the water filter alarm, the
and red, the button lights up white.
Once the water filter alarm is emitted, please proceed as follows:
1. Press the Prog. button.
2. Remove the water tank, remove the water filter, rinse the water tank and insert
a new filter. Fill the tank with cold water up to the Max-marking and reinstall
the water tank. Please refer to page 14 –15 for information on how to install the
MAVEA Intenza water filter.
3. Place the container under the brewing group.
4. Press the button to activate the automatic rinse cycle. 16.9 fl oz of water are
fed through the appliance.
5. Once the and
operation mode.
button alternately flashes white
buttons constantly light up white, the appliance is back in
EN
31