Troubleshooting And Solutions - HumanTechnik ASATech Signolux S Mode D'emploi

Troubleshooting and solutions

Symptoms
When trying to program
a transmitter, a different
icon lights up...
The red status LED light
up with an alert...
The »signolux« receiver
does not work...
There is no alert tone...
The flash light does not
work...
14 English
Cause
The transmitter you are
trying to program is
already known by the
receiver.
This indicates a low
battery in the according
transmitter.
Ensure that the
rechargeable batteries
have been inserted
correctly.
Check if the batteries are
charged
Maybe the triggered
transmitter has not yet
been paired with the
»signolux« receiver.
Perhaps the »signolux«
receiver is out of reach of
the transmitter.
mode selector switch is
on position 2 (fig. 2)
mode selector switch is
on position 0 (fig. 2)
Solutions
See step 7. Delete the transmit-
ter from the receiver's memory
before it can be assigned to a
new icon.
Insert a new battery in the
transmitter.
Ensure correct polarity of the
rechargeable batteries!
Connect the receiver to the
power supply.
Assign it to an icon.
Try using the transmitter or
receiver at different location.
Check the position of the
switch (fig. 2) on the »signolux«
receiver.
Ensure that the volume is not
set to the lowest setting.
Check the position of the
switch (fig. 2) on the »signolux«
receiver.