Troubleshooting And Solutions - HumanTechnik signolux A-2617-0 Mode D'emploi

Troubleshooting and solutions

Symptom
When trying to program
a transmitter, a different
icon lights up.
The red status LED lights
up with an alert.
The receiver does not
work.
There is no alert tone.
The flash light does not
work...
14 English
Cause
The transmitter you are
trying to link has been
already linked with the
receiver.
This indicates a low
battery in the according
transmitter.
The batteries may be
inserted incorrectly.
The batteries are
depleted.
The triggered transmitter
has not yet been paired
with the »signolux«
receiver.
The receiver is out of
transmission range.
Mode selector switch is
on position 2
Mode selector switch is
on position 0
Solution
Delete the transmitter from the
unwanted icon before it can be
assigned to a new icon.
Insert a new battery in the
transmitter.
Ensure the correct polarity of
the rechargeable batteries!
Connect the receiver to the
power supply.
Follow the linking procedure to
assign it to an icon.
Try using the transmitter or
receiver at a different location.
Check the position of the switch
(9) on the rear of the receiver.
Ensure that the volume is not
set to the lowest setting. Rotate
the control clockwise to turn up
the volume
Check the position of the switch
(9) on the rear of the receiver.