HumanTechnik ASATech Signolux S Mode D'emploi page 4

5. Programming signals and
assignment to the event icons
Up to 8 transmitters can be assigned to
each event icon. This assignment can be
adapted by programming. Kindly keep in
mind that a transmitter can only be pro-
grammed if it is not yet known in the mem-
ory of the »signolux« receiver. If required,
you first might have to delete the transmitter
from the memory (see step 7).
a) Keep the function button »
pressed for some time. The event icons
start to light up in sequence. Let go of
the key as soon as you see the desired
icon.
b) Trigger your transmitter (e.g. operate
the doorbell pushbutton or test button).
c) Wait for about 20 seconds and test the
function.
6. Setting the melody
You can adapt the melody for each icon:
a) First trigger an alert (e.g. operate door-
bell pushbutton).
b) The icon assigned to the transmitter
should light up and the previously cho-
sen tone should be heard.
c) Press and hold the melody setting but-
ton »♫« (fig. 2) for two seconds.
Let go of the button and press it repeat-
edly until you have found the desired
melody (you can choose from 15 different
tones).
d) Once the icon ceases to flash, the
selected tone has been assigned.
12 English
7. Deleting transmitters from receiver
memory
Do the following if you want to delete a
transmitter from the memory:
a) Keep the function button »●« (fig. 2)
pressed for some time. The event icons
light up in sequence. Let go of the key as
soon as you see the desired icon.
b) Now press the function button »●« and
the melody button »♫« (fig. 2) at the
●«
(fig. 2)
same time, until all icons briefly light up.
Please note that this will remove all as-
signed transmitters from the selected event
icon.
8. Battery level indication
The receiver informs about the state of the
batteries of the receiver as well as the bat-
teries of the transmitters:
- A sufficient battery charge level of the
receiver is indicated by the red status
LED flashing every 5 to 6 seconds.
- A low battery level of the receiver is in-
dicated by the red status LED flashing in
short sequence (once per second).
Please recharge the receiver batteries as
soon as possible (attach it to the power sup-
ply unit).
- A low battery level of a transmitter is indi-
cated by the staus LED blinking
together with the icon of the according
transmitter when its signal is triggered.
Please replace the batteries of the accor-
ding transmitter as soon as possible.