Milk Circuit Wash Cycle - Saeco Primea Touch Plus Mode D'emploi

28 PROGRAMMING THE MACHINE

MILK CIRCUIT WASH CYCLE

To rinse the machine's internal circuits used for preparing milk.
After 14 days from the fi rst dispensing of a beverage with milk, the "milk cleaning" button stars fl ashing
(see page 13). Press the button and refer to instructions at point 2. This cycle must be performed after 21 days.
Refer to the instructions at point 3.
Before performing this function make sure that:
1. a large enough container is at hand.
2. the milk container has been adequately cleaned of all milk residue.
3. the water tank contains a suffi cient quantity of water.
THE WASH CYCLE CANNOT BE INTERRUPTED. A PERSON MUST BE PRESENT DURING THE OPERATION.
USE ONLY AND EXCLUSIVELY THE PROVIDED DETERGENT.
1
lock
display
milk
cleaning maintenance
cycle
milk
rinsing
cycle
go back
Select the function by
pressing the "milk cleaning
cycle" button.
4
milk cleaning cycle
dispensing hot water...
Wait...
7
Open the compartment and
insert the container with the
detergent into the machine.
coffee
2
cleaning
cycle
descaling
cycle
back to
menu
Position the milk container
under the water spout.
5
add detergent to the milk tank
and insert it into the machine
When the container is fi lled the
above message will appear.
8
add detergent to the milk tank
and insert it into the machine
Close the compartment. Press
the "ok" button.
milk cleaning cycle
milk cleaning cycle
ok
3
milk cleaning cycle
dispense hot water into
the milk tank
start hot
go back
Press the "start hot water"
button to dispense hot water
in the container.
6
Insert the detergent tablet
into the container.
9
milk cleaning cycle
please wait until the detergent
is resolved
Wait...
Place a container beneath the
hot water spout.
water