GYS TRIMIG 200-4S Mode D'emploi page 13

COMMAND KEYBOARD (FIG-V)
Choice of the welding mode (2)
- NORMAL (2T) : standard welding 2T
- NORMAL (4T) : standard welding 4T
- DELAY : « chain stitch » function, with spot delay setting
- SPOT : spot function, with adjustment of the spot diameter
Wire speed adjustment potentiometer. The speed varies from 1 to 15m/
minute.
SPOT/DELAY potentiometer (5)
Manual mode (1)
In manual mode, the wire speed is determinated by the user by adjus-
«MANUAL» MODE (FIG-V)
To set your device, proceed as follow:
• Choose the welding voltage using the 7-10 or 12 positions switch (depending on the product)
- Example:
To weld 1 mm thick steel, set the switch to 1
• Adjust the wire speed with the potentiometer(4).
- Recommendations:
The wire speed adjustment is often determined « with the assistance of sound »: the arc must be stable and have a low crackling. If the speed is
too low, the arc is not continuous. If the speed is too high, the arc crackles and the wire pushes back the torch.
«SYNERGIC» MODE (FIG-V)
With this function, no need to adjust the wire speed anymore.
• Set the wire speed potentiometer (4) in the middle of the« Optimal synergic » zone. • Select:
-The wire type (3)
-The wire diameter (3)
Then to select the right position in accordance with the thickness of the workpiece, please refer to the table «Synergic mode» fig. VI. From this com-
bination, the device determines the optimal wire speed and the device is ready to weld. It is also possible to adjust the wire speed if necessary by
adjusting the potentiometer (4) + or – manually. Settings are saved and loaded each time the user switches the machine back on.
RISK OF BLESSING RELATED TO MOBILE COMPONENTS
The wire feeders contain moving parts that may catch hand, hair, clothes or tools which can lead to injuries! Take extra care.
• Do not place your hand on mobile/pivoting/wire feeding parts of the machine!
• Make sure that all panels remain closed when in use !
Do not wear gloves when setting up the wire and changing the wire reel.
RECOMMENDATIONS AND THERMAL PROTECTION
• Ensure the air intakes of the device are not blocked to allow adequate air circulation.
• Leave the device plugged after welding to allow its cooling.
• Thermal protection: The light turns on and the cooling duration is a couple of minute according to the area temperature
TRIMIG
ting the potentiometer (4).
Synergic mode (3)
Set the potentiometer (4) in the middle of the « OPTIMAL SYNERGIC »
zone.
In this mode, the device determines the optimal wire speed according
to 3 parameters:
- Voltage
- Wire diameter
- Wire type
It is possible to adjust the wire speed +/- with the potentiometer (4).
EN
13