Attaching The Rear Housing Wall - Abus FU 8230 Instructions D'installation

Sirène radio intérieure
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
5
2
6

Attaching the rear housing wall

1. Using the base plate as a drilling template, mark the drill
holes on the wall. Drill the holes and insert wall plugs if
necessary.
2. Feed the connection cable of the PSU into the device and
screw the rear housing side onto the wall (optional).
3. Supply the internal siren with power (either 4.5 V or 12 V,
or both - the polarity of the terminal block is printed on the
PCB).
Assigning the Secvest to the wireless internal siren
1. Set the "LEARN" jumper. LED1 starts to flash. Learning
mode is now active.
2. In the installer menu of the wireless alarm centre, select
the "Other Devices  Info Module/Int Siren  Teach
Device" menu point.
3. Press "Send" on the wireless alarm centre.
The centre sends the learn signal to the internal siren.
After successful learning of the wireless alarm centre:
4. Remove the "LEARN" jumper. The ID of the alarm centre
is saved in the internal siren. The internal siren emits a
double tone.
The internal siren emits a double tone.
LED1 goes out.
12
1
4
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

SecvestFusg50110

Table des Matières