•
•
Place the pressure vessel lid
Note: Do not turn the lid horizontally on its head.
•
Stand on the kick loops
the mantle handles
•
Take your feet off the kick loops
the mantle handles
•
Remove exhausted fi lter cartridge
•
Place the exhausted fi lter cartridge
remaining water (> 5 min.).
•
Lock the exhausted fi lter cartridge
cartridge and return in the original packaging to the appropriate BRITA address listed on the
back of the cover.
6.2 Inserting the Filter Cartridge
•
•
•
•
•
•
•
Switch on power supply to the terminal device (plug).
•
To fl ush and bleed the new fi lter cartridge
30
Stand on the kick loops
lid
by pressing the lock
3
The fi lter cartridge
is released by pressing on the mantle handle
2
vertically on both lid handles
3
with both feet while turning the pressure vessel
12
as far as it will go.
16
and press the pressure vessel
12
.
16
from the pressure vessel
2
in the sink with the connection facing down to drain the
2
with the transport protective cap
2
Check that the O-ring seal of the fi lter cartridge
groove and also check for dirt and damage.
Note: The cartridge seat has been lubricated with food-safe lubricant at the
factory.
Check the connector seat of the fi lter cartridge O-ring
lid
for dirt and damage.
1
Place the new fi lter cartridge
Stand on the kick loops
clockwise until the mantle handle
Stand on the kick loops
lid
on the pressure vessel
3
lid handle
must line up with the "INSERT" groove.
20
Press the pressure vessel lid
engages.
with both feet while opening the pressure vessel
12
and turning it anticlockwise as far as it will go.
15
.
20
in the pressure vessel
2
with both feet, lift the pressure vessel
12
is over the kick loops
16
with both feet and place the pressure vessel
9
. The positioning of the arrow marking on the
1
down and turn clockwise until the lock
3
carry out the steps described under 5.3.
2
16
anticlockwise by
1
down with both hands on
1
.
1
of the new fi lter
18
is correctly seated in the
2
in the pressure vessel
2
.
1
turning it
1
.
12
.
15