Preparing Programing & Installing Your Electronic Smartdoor - Petsafe Electronic SmartDoor Guide D'emploi

Preparing Programing & Installing Your
Electronic SmartDoor
Step 1: Choose a Location for your Door
Household appliances (such as laptop computers, wireless telephones, microwave ovens and televisions)
should be at least 2 feet (60 cm) away from the SmartDoor
Step 2: Install the 4 D-Cell Batteries
1. With a Phillips screwdriver, remove the two Battery Box
Cover screws.
2. Remove the Battery Box Cover.
3. Refer to the inside of the Battery Box Cover for the proper
orientation of the four D-Cell batteries.
4. Replace the Battery Box Cover and re-install the 2 Battery
Box Cover screws.
5. When the batteries are placed in the Electronic
SmartDoor the red LED will illuminate for 2 seconds
™
and the fl ap will move into the locked position. If the
fl ap is already in the locked position nothing will happen.
Note: The door must be in the vertical position for the fl ap to
center properly and operate correctly.
Step 3: Install the PetSafe
1. Place the PetSafe ®
SmartKey ™ .
2. Using a coin, rotate one-quarter turn clockwise to secure
the PetSafe ® RFA-67 battery.
Note: The SmartKey
the LED begin to fl ash, the PetSafe
low on charge and should be replaced as soon as possible. In more current SmartKeys
illuminate for 2 seconds when the battery is installed.
RFA-67 battery into the bottom of the
™ has a red LED inside the housing. Should
® RFA-67 battery is getting
™
™ .
® RFA-67 Battery in the SmartKey
www.petsafe.net
™ , the LED light will
™
5