Training Your Pet To Use The Electronic Smartdoor; Troubleshooting; Replacement Parts - Petsafe Electronic SmartDoor Guide D'emploi

Masquer les pouces Voir aussi pour Electronic SmartDoor:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Training Your Pet to Use the Electronic SmartDoor

To begin training your pet to use the Electronic SmartDoor
set the Electronic SmartDoor
SmartKey
to your pet's collar. Temporarily tape the fl ap up to the
surface in which your pet door is mounted to hold the fl ap open.
Sometimes it helps for you to be on one side of the door and your
pet on the other. Use food or treats to coax your pet through the
open pet door. Let the pet become familiar with passing through the
pet door with the fl ap up.
In time, remove the tape and let the fl ap hang in the Unlocked mode.
Again coax your pet through the pet door with food or treats. After your
pet becomes accustomed to pushing through the fl ap, set the Collar ID
door to the Automatic mode. When the pet is near the Collar ID door
and the fl ap unlocks, again coax the pet through with food or treats.
Electronic SmartDoor
will not lock.
Electronic SmartDoor
does not respond to the
presence of the SmartKey
transmitter.
Electronic SmartDoor
becomes jammed on the
edge of the door frame.
Please call Customer Care Center at 1-800-732-2677 (US), 1-800-457-3911 (Canada) for further assistance.

Replacement Parts

To purchase replacement parts for your PetSafe
Center at 1-800-732-2677 (US), 1-800-457-3911 (Canada) or visit our website at www.petsafe.net to
locate a retailer near you.
Component
PetSafe
®
RFA-67 Battery
Flap (Small)
Flap (Large)
Battery Cover Screws
Battery Cover
Range Adjustment Knob
SmartKey
to the Unlocked mode. Attach the

Troubleshooting

• Make sure the flap is in the center position and repeat the operating
cycle.
• Check that the Electronic SmartDoor
• Check that the SmartKey
SmartDoor
• Check that the Range Knob is fully clockwise.
• Check that the PetSafe
in tightly.
• Check that the batteries in the Electronic SmartDoor
• If the condition persists, check that there are no radio-frequency
transmitting devices or electronic devices that radiate electrical energy,
which may interfere with the operation of the Electronic SmartDoor
fl ap
• Use both hands to push the flap to the center. DO NOT PULL UP
ON THE FLAP. Press the "Mode/Reset" button and the flap should
move into the locked position.
• If you cannot move the flap to the center, force it completely outside of
the door frame opening. Note: push it in the direction that is easiest to clear
it from the center of the door.
• Reset to Locked mode and the flap will raise, then reset to Automatic
mode.
www.petsafe.net
, fi rst
has been "learned" by the Electronic
.
RFA-67 battery in the SmartKey
®
®
Electronic SmartDoor
Part Number
RFA-67
615-049
615-064
202-231
700-967
700-1139
PAC11-11045
is in Automatic mode.
are fresh.
, contact the Customer Care
is screwed
.
7

Publicité

Table des Matières
loading

Table des Matières