Use Of Anthea; Brightness Control; Warning Signal Adjustment - BEN Marine ANTHEA Notice D'utilisation Et D'installation

5. USE OF ANTHEA

5.1 BRIGHTNESS CONTROL

Press (*) to adjust brightness.
Optimum brightness can be adjusted on speed circular bargraph.
When (*) key is released, the circular bargraph resumes its speed indicating function.
Press "Dist/Reset" to reset daily totalizer appearing on LCD screen.
Scale change on LCD screen:

5.2 WARNING SIGNAL ADJUSTMENT

There are two alarm thresholds, upper and lower threshold.
LCD screen (2 x 16-digits lines) gives following informations :
When the alarm is inhibited, there is a star (*) on the beginning of one of the 2 LCD lines.
With  and  keys desired alarm threshold can thus be adjusted. Then, press
second alarm threshold. The star then appears on second line. The second alarm threshold can
then be adjusted.
"ALARM ON" to validate previously entered adjustments. Stars on message
Press
beginning disappear.
Alarm detection then becomes operational.
If the ship speed exceeds preset thresholds, corresponding warning signal lights up.
Press "ALARM ON" once again to validate the buzzer.
Press "ALARM OFF" once to suppress the buzzer.
To put it on again, press "ALARM ON".
Press "ALARM OFF" once again to suppress the alarm function.
This document is Avantix property and cannot be copied or transmitted without the company's authorization
*
Low speed xx.x
High speed xx.x
97MU001-F
ANTHEA OPERATION AND INSTALLATION MANUAL
33-B
to alter