BEN Marine ANTHEA Notice D'utilisation Et D'installation page 100

4. APPLICATION I LIMITATION:
Page 3/ 4
Certificate number:
42620/AO
EC
4.1 - As per requirements of regulations stated on the front page of the certificate and according to the manufacturer's
specifications.
4 .2 - This certificate does not cover the hull fittings which are to be type approved
4 .3 - Configurations:
4 .3. 1 Configuration 1: Hull fitting and associated sensor- 481 series
Hull
fitting Associated Sensor
Reference and description Reference and description
PUBEN01 6
PUBEN008
Hull fitting 48 1 RVI with valve for steel hulls (weld-on type) 48 1 RVB 16 sensor, retractable at sea
PUBEN015
Hull fitting 48 1 RVB with valve for wood and FRP hulls (screw-on type)
PUBEN014 PUBEN059
Hull fitting 481 Rl without valve for steel hulls (weld-on type) 481 RB 16 sensor
PUBEN063
Hull fitting 481 RB without valve for wood and FRP hulls (screw-on type)
PUBEN062 PUBEN058
Hull fi tting 481 RA without valve for aluminium hulls (weld-on type) 48 1 RA 16 sensor
4 3 2 - Configuration 2 · Hull fi tting and associated sensor - 65 I series
..
Hull fitting Associated Sensor
Reference and description R efer ence and description
IPVBEN350 PUBEN056
!Hull fitting 65 1 RVI with valve for steel hulls (weld-on type) 652 RVB 20 sensor, retractable at sea
IPVBEN349
!Hull fitting 65 1 RVB with valve for wood and FRP hulls (screw-on type)
4 3 3 - Configuration 3: Lens hull fitting and lens sensor
..
Hull fitting Associated Sensor
Reference and description Reference and description
IPVBEN308 PVBEN306
1
Lens steel hull fitting Lens sensor
IPVBEN308-0 1
[Lens aluminium hull fitting
Note:
-Hull fitting with valves PUBEN 015 - PUBEN 0 16 - PVBEN 349, PVBEN 350 are used on all type of vessels.
- Hull fitting without valves PUBEN 014 - PUBEN 062- PUBEN 063, are used as follows:
*
On board vessels of less than 500 gross tonnage.
*
Onboard Fishing ships not longer than 45 m
*
Onboard Yachts
5. PRODUCTION SURVEY REQUIREMENTS:
This certificate alone does not allow the applicant to issue the Declaration of Confom1ity and to affix the mark of conformity
(wheelmark) to the products conesponding to this type. To this end, the production-control phase module D "Production Quality
Assurance" orE "Product Quality Assurance" or F "Product Verification" of Annex B of the Directive is to be complied with
and controlled by a written inspection agreement with a Notified Body.
6. MARKING O F PRODUCT:
6. I - Maker's name or trade mark,
- Serial number of the units,
- Equipment type number or model identification under which it was type-tested,
- Compass minimum safe distance according to IEC 60945.
6.2 - Markings as perMED 96/98/EC:
$
YYYY/X.X where YYYY is the number of the Notified Body undertaking survei llance module (when BV, 0062) and where
XX are the last two digits of year mark affixed.
The electronic version is available at: http://www.veristarnb.com/veristarnb/jsp/viewPublicPdfTypec.jsp?id=b3avyeym1o
BV Mod. Ad.E 536 December 2014 This certificate consists of 4 page(s)