BEN Marine ANTHEA Notice D'utilisation Et D'installation page 47

24-B
4. TESTS, ADJUSTMENTS AND CALIBRATION UPON FIRST USE
Preliminary tests
Once installation is completed, a first test must be performed before turning the power
on.
Open the ANTHEA and move the Normal - Test switch (S1) to the Test position. If
nothing appears on the speed repeater, this means that the ANTHEA is not receiving any
current.
Check the battery charge, then the fuse.
When working, the log is at about 80 % of the scale in Test mode.
In case a GA120 galvanometer is used, make sure that strap position corresponds to the
galvanometer scale, that is:
E6
E5 E4 E3
- 2 + 16 knots
- 3 + 24 knots
0 + 32 knots
0 + 48 knots
97MU001-F
ANTHEA OPERATION AND INSTALLATION MANUAL
This document is Avantix property and cannot be copied or transmitted without the company's authorization