Operating The Appliance; Switching The Appliance On And Off; Status Display; Startup After Power Failure - Bosch TR4000 Notice D'utilisation

Cleaning

2.2

Operating the appliance

2.2.1

Switching the appliance on and off

The continuous-flow heater switches on and heats the water when
the warm water tap is opened. It switches off again if the water tap
is closed.
The factory default setting for the warm water outflow temperature
is 55 °C.
Note: The electronic control unit senses the input water's temperature
and rate of flow and automatically adjusts the power consumption in
order to obtain the set output water temperature (up to the power limit).
Increasing the water temperature
If the supply water temperature is low and the flow-rate is high, then it
may happen that the set output water temperature is not obtained
because the power limit is exceeded. This is signalled by rapid flashing of
the status display.
• If this happens, then slightly close the warm water tap.
2.2.2

Status display

LED Appliance status
Off Off
Lights green On
Flashes green (1/s) The set temperature is not obtained; the rate of
water flow is too high for appliance rating
(the appliance has reached the power limit).
See "A fault, what to do?"
Flashes green (2/s) Cold-water rinse-through phase
Flashes red See "A fault, what to do?"
6
2.2.3

Startup after power failure

• Open the warm water tap fully and allow water to flow until it is warm.
2.2.4 Using the appliance after switching off the water supply
• Switch off the appliance (unscrew the fuse in the fusebox).
• Open the warm water tap and keep it open until the air has been
completely forced out of the water pipe.
• Switch the fuse back on again.
• Open the warm water tap fully and allow water to flow for at least one
minute.
Only then (for safety reasons) will the appliance begin to heat.
The appliance is now ready to operate.
2.2.5

Winter operation

Note: It is possible in winter that the supply temperature of the water is
reduced and the required outlet temperature is no longer achieved.
• Reduce the water flow at the tap until the desired water temperature
is reached.
3 Cleaning
• Only wipe off the appliance using a moist cloth.
• Do not use acidic or abrasive cleaning materials.
• Do not use a steam cleaner.
4

Customer Service

We ask you to always provide the BOSCH serial number (SNR/TTNR) of
your appliance when calling in a customer service engineer. You will find
the numbers on the ratings plate on the inner side of the front flap.
5

Environmentally-friendly disposal

• Dispose of the packaging in an environmentally sound manner.
This appliance is labelled in accordance with European
Directive 2012/19/EU concerning used electrical and
electronic appliances (waste electrical and electronic
equipment – WEEE).
The guideline determines the framework for the return and
recycling of used appliances as applicable throughout
the EU.
Please ask your specialist retailer about current disposal
facilities.
Subject to change without notice.
TR4000 – 6 720 876 041 (2018/04)