EUROM Force 1420S wet/dry Manuel D'utilisation page 14

Operation
 Put the hose
machine; if necessary, turn it a bit till
the narrow part is in total in the
machine. Then turn it as far as
possible clockwise.
 After this, connect the accessories
you wish with a twisting force, see
picture.
 You can adjust the telescope tube by
pushing the sliding block 2A down
and tracking/pushing the lowest tube
to the length you wish.
 Insert the plug into the socket.
 Press the switch on/off to I to turn on.
 You can adjust the airflow by pushing the sliding
block 1B up and down.
 If necessary, due to the surface and task, the hair
or rubber strips can be removed from the suction
mouth. In order to do so, slide the discs on the
suction mouth outwards, take the strip holder from the
suction mouth, slide the excess strip out and replace
the holder.
 For the vacuuming of liquid the motor (which is
situated in the cap) is provided with a floater that is
hanging under the motor, in the barrel. For the
vacuuming of dry dirt and dust the motor is provided
with a filter that the floater surrounds and in that way
prevents that dust enters the mechanic system. Do you
want to vacuum liquid, remove than the filter by
opening the locking blocks, to lift and turn the cap, to
turn the lid from the filter (see image), and to slide the
filter from from the floaters frame. Now you can
remove the filter. Bring the cap back in its position and close the blocks.
the supplied black filter around the float
Be carefull!
 Never vacuum dust without the filter around the floater!
 Never vacuum liquid with the filter around the floater!
Socket
In order to use the socket, you must lift the lid and insert the plug into the socket.
Then use the ON/OFF switch to select the appropriate setting:
I = device works, power from socket
connection in the
14
Place