Installation; Unpacking; Mechanical Installation; Imaging Quartet Series Trays - Miranda AAP-711i Notice D'installation Et D'utilisation

Guide to installation & Operation

2 Installation

2.1 Unpacking

Make sure the following have been shipped with your AAP-711i or AAP-712i. If any of the following
items are missing, contact your distributor or Miranda Europe.
•
AAP-711i or AAP-712i
•
AAP-711i or AAP-712i rear panel label

2.2 Mechanical installation

The AAP-711i or AAP-712i must be mounted within Quartet-A110 tray or in Symphonie equipped
with rear module R-AX or R-A110 in order to provide power to the card.
This section describes how to install the AAP-711i or AAP-712i in any of these trays. It is not
necessary to switch off the power from these trays when installing the AAP-711i or AAP-712i

2.2.1 imaging Quartet series trays

To install this card into Quartet follow these steps. For a closer look at card installation and removal,
refer to the tray's technical manual.
1. Remove the tray's front panel by rotating the thumbscrews counter clockwise. Pull on
the handles.
2. Select an empty slot
3. Carefully place the AAP-711i or AAP-712i between a set of card guides and gently
push the card towards the rear of the tray until the card edge connector is secured to
the back plane. The card's edge connector having 96 points, it may be necessary to
push lightly when connecting the two connectors. Pull lightly on the card verifying that
it does not move.
4. Replace the tray's front panel. Make sure to rotate the thumbscrews clockwise in order
to secure it to the chassis.
2
AAP-711i - AAP-712i