The Setup Menu {Conf - Miranda AAP-711i Notice D'installation Et D'utilisation

Guide to installation & Operation

3.4.17 The setup menu {CONF}

Two factory setups (STAL, MOD1) reset all parameters to their original values programmed during
manufacturing and two user setups (USR1, USR2) are available. They allow saving two board
configurations into a non-volatile memory. The table below lists the default values of the factory
setups. The USR1 and USR2 commands can be accessed by remote control.
Save setup procedure
• Press [+] or [-] to display {CONF},
• Press [SEL] displays LOAD, use [+] to display SAVE,
• Press [SEL] again displays USR1, use [+] or [-] to scroll through the available values: USR1, USR2.
• Press [SEL] to store the new setup, and to return to the previous menu
• Or press [ESC] to return to the previous menu without updating the parameters.
• To turn off the display, press [ESC].
Load setup procedure
The first setup STAL means stand alone mode. The MOD1 setup is intended for use with a video
processor: reference and tracking delay inputs are issued from the front panel Abus connector, the
AAP-712i will convert the analog signals, process and send them to the video processor module for
embedding. This mode supposes a flat cable link (ABUS) between the AAP-712i and the video
processor module.
• Press [+] or [-] to display {CONF},
• Press [SEL] displays LOAD,
• Press [SEL] again displays STAL, use [+] or [-] to scroll through the available values: STAL, USR1,
USR2, MOD1.
• Press [SEL] to recall the new parameters, and to return to the previous menu
• Or press [ESC] to return to the previous menu without updating the parameters.
• To turn off the display, press [ESC].
DLAY
SWAP
LVL
PHSE
MIX
TEST
OLVL
MUTE
MNTR
ALRM
ABUS
AES
ORIG
DEST
SRWL
26
AAP-711i - AAP-712i
STAL
FIX = 0 ms
TRAK = OFF
LINK = OFF
I-1L > -1L
I-1R > -1R
I-2L > -2L
I-2R > -2R
0 dB
NORM
OFF
OFF
0 dB
OFF
ENAB = OFF
OFF
REF = "BNC",
AES = "SUBD-BNC"
TRAK = RJ45
PRO
BLANK
BLANK
OSR = 48k
OWL = 24bt
MOD1
FIX = 0 ms
TRAK = OFF
LINK = OFF
I-1L > -1L
I-1R > -1R
I-2L > -2L
I-2R > -2R
0 dB
NORM
OFF
OFF
0 dB
OFF
ENAB = OFF
OFF
REF = ABus
AES = ABus
TRAK = ABus
PRO
BLANK
BLANK
OSR = 48k
OWL = 20bt