Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Guide to installation & Operation
2 Installation
2.1 Unpacking
Make sure the following have been shipped with your UAP-711i or UAP-712i. If any of the following
items are missing, contact your distributor or Miranda Europe.
•
UAP-711i or UAP-712i
•
UAP-711i/UAP-712i rear panel labels::
One for R-AX Symphonie rear panel
One for R-A110 rear panels
2.2 Mechanical installation
The UAP-711i or UAP-712i must be mounted within Quartet-A110 tray or in Symphonie equipped with
rear module R-AX or R-A110 in order to provide power to the card.
This section describes how to install the UAP-711i or UAP-712i in any of these trays. It is not necessary
to switch off the power from these trays when installing the UAP-711i or UAP-712i
2.2.1 imaging Quartet series trays
To install this card into Quartet follow these steps. For a closer look at card installation and removal,
refer to the tray's technical manual.
1.
Remove the tray's front panel by rotating the thumbscrews counter clockwise. Pull on the
handles.
2.
Select an empty slot
3.
Carefully place the UAP-711i or UAP-712i between a set of card guides and gently push
the card towards the rear of the tray until the card edge connector is secured to the back
plane. The card's edge connector having 96 points, it may be necessary to push lightly
when connecting the two connectors. Pull lightly on the card verifying that it does not
move.
4.
Replace the tray's front panel. Make sure to rotate the thumbscrews clockwise in order to
secure it to the chassis.
6
x UAP-711i/712i
Publicité
Table des Matières
