Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.3 Menu introduction
Most AAP-711i or AAP-712i parameters are accessed and changed via an easy-to-use menu. The
flow chart below outlines the entire AAP-711i or AAP-712i menu path. Each menu is described
throughout this section. The following items should be remembered when accessing the menu.
Automatic display turn off after 1-minute interval
If the menu is currently being accessed and no push-button has been pressed for 1 minute, the AAP-
711i or AAP-712i automatically turns off the display. A press on any push button [-], [+] or [SEL] will
turn on the display without any change on the current parameter.
Navigating through the menu
This section describes how to use the front panel push buttons to navigate through the menu.
[+]
Press [+] to move down in the menu or to increase the parameter value. For example, if
you are currently at {I-1&2}, pressing [+] will scroll downwards through the selection {I-
1}.
Depressing [+] during an adjustment will increase the parameter value at faster rate.
[-]
Press [-] to move up in the menu or to decrease the parameter value. For example, if
you are currently at {PHSE}, pressing [-] will scroll through the selections {LVL},
{SWAP}, {DLAY} and {STAT}.
Depressing [-] during an adjustment will decrease the parameter value at faster rate.
[SEL]
Changes to a menu parameter are stored immediately to non-volatile memory. For
example, after the L gain value has been set, press [SEL] and the new value is stored
for the current format and AAP-711i or AAP-712i returns to previous menu.
[ESC]
If [ESC] is pressed after changes to a parameter, the parameter is reset to the value it
had
prior
[ESC] the previous value is reloaded and AAP-711i or AAP-712i returns to previous
menu. When on root menu, a press on [ESC] turns off the display.
Note:
If the L and R values are different, the L value will be displayed after a L&R selection.
On the same way, the channel 1 value will be displayed after an I-1&2 or O-1&2
selection. Modify the displayed parameter attached to the 1&2 selection to change the
channel 2 value.
to
the
change,
For
Guide to installation & Operation
example,
after
changing
AAP-711i - AAP-712i
L
level,
press
13
Publicité
Table des Matières
