Important; Introduction; General Notes - LD Systems MAUI 5 GO Manuel D'utilisation

11. Do not drop the device or battery. If the device or battery is dropped, especially onto a hard surface, either or both could be damaged.
12. If the standby time of the device is significantly reduced, replace the battery.
13. If the device has a built-in, non-removable battery, do not attempt to remove the battery, because this could cause damage to the
device. Take the device to an authorised service centre for replacement of the battery.
IMPORTANT: Charge the battery only with the dedicated charging system (charging system in MAUI 5 GO Subwoofer, charging dock
LDMAUI5GOCD)

INTRODUCTION

Perfectly equipped throughout, the MAUI® 5 GO is the ultimate system to deliver crystal-clear, powerful sound in any location. The bat-
tery-powered column-PA is supplied by a high-performance lithium-ion unit. The charger is built into the subwoofer. An external charging
dock is available as an accessory. Inputs for microphone, instrument and line signals as well as Bluetooth® stereo streaming make the
MAUI 5 GO the ideal system for street musicians or for music and speech reproduction at private and business events and all mains
®
power-free applications. Its superlight weight of just 13 kg makes the four-piece design ultra-easy to transport, and thanks to its special
multipin connectors, it is assembled and ready to use in seconds. The line-array arrangement of the drivers achieves an extremely high
range. The system's wide dispersion and excellent feedback-resistance removes the need for separate monitors. For unparalleled sound
quality in all applications, the column system features LD Systems' LECC DSP with multi-band limiter, equalizer, compressor and crossover.
The integrated 4-channel mixer provides separate volume controls for the input channels, sum and subwoofer as well as a variable
high-frequency boost to facilitate fast and balanced adjustment to the sound.

GENERAL NOTES

The subwoofer of the LD MAUI 5 GO speaker system must be positioned vertically on a flat surface on its feet prior to operation. Never
operate the system on a trolley, because there is a risk that the entire system may begin to move in an uncontrolled manner. This may result
in accidents and damage. To ensure sufficient cooling during operation, a minimum distance of 50 cm must be maintained between the
back of the subwoofer and other similar objects such as walls.
Please ensure that the system as well as any connected devices such as mixing consoles, CD players etc. are connected to the correct
audio and power connections. Use only undamaged cables with a suitable diameter and always unroll cable reels fully. Use cable protectors
to avoid tripping accidents caused by loose cables. Never position the device directly on an edge. Do not place the subwoofer on a table. In
order to eliminate unwanted noise when turning on connected devices, always switch the system on last and switch it off first.
ASSEMBLY
The LD MAUI 5 GO speaker system comprises four components:
A. Subwoofer with integrated electronics for all system components, including a charging module for charging the battery and a connection
for the column sections on the top side.
B. Column section with integrated rechargeable battery, charging status display and connections on the underside and top side.
C. Spacer with connections on the underside and top side.
D. Column section with speakers and connector on the underside.
After the subwoofer has been placed in the desired position, the column sections with integrated rechargeable battery and spacer are
attached to the subwoofer, then the column section to the speakers. Depending on the application, the speaker system may also be used
without the spacer.
The MAUI 5 GO speaker system can be used either connected to the mains or independently of the mains by using the column section
with built-in battery. When operating on AC power, the battery is charged automatically. The operating time for battery application can be
prolonged by replacing column sections with an empty battery with column sections with a fully charged battery (available as an option).
Replacing the battery takes only a few seconds and the system is once again ready to use.
5