Cable Connectors - afx light SPOT 60 LED Manuel D'utilisation

SPECIFICATIONS
Voltage: . ............................................................................................................. 1 00‐230Vac/ 50‐60Hz
Power consumption: . ..................................................................................................................................... 90W
Light source: ............................................................................................................. 1 led of 60W White
Color : . ................................................................................................................. 7 color + white
Gobos : . ...................................................................................................... 6 Rotating + 8 fixed
Pan: . ................................................................................................................... 1 80°, 360°, 540°
Tilt: . ...................................................................................................................... 9 0°, 180°, 270°
Angle: . .................................................................................................................. 1 7° to 25° max
Brightness : . ........................................................................................................ 24500 Lux max
Function: .......................................... S ound control, Auto‐run, Master/Slave, DMX512, Strobe
Channel: .......................................................................................................... 1 4 DMX channels
Data input . ................................................................................... Locking 3‐pin XLR male socket
Data output ............................................................................ Locking 3‐pin DMX female socket
Data pin configuration ................................................................. Pin1 shield, pin 2 (‐), pin 3 (+)
Dimensions . ...................................................................................................... 2 46x348x250mm
N.W: ................................................................................................................................... 6.5kg
SETUP
Fuse Replacement
With a flat head screwdriver wedge the fuse holder out of its housing.
Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
Insert the fuse holder back in its place and reconnect power.
The fuse is located inside this compartment. Remove using a flat head screwdriver.
Fixture Linking
You will need a serial data link to run light shows of one or more fixtures using a DMX‐512 controller or to run
synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all fixtures on a serial data link determines the number of fixtures that the data link can
support.
Important: Fixtures on a serial/data link must be daisy chained in one single line. Maximum recommended serial
data link distance: 500 meters (1640 ft.) Maximum recommended number of fixtures on a serial data link: 32 fixtures
Data Cabling
To link fixtures together you must use data cables. If you choose to create your own cable, please use data‐grade
cables that can carry a high quality signal and are less prone to electromagnetic interference.
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
DMX connector configuration
Termination reduces signal errors. To avoid signal transmission problems and interference, it is always advisable to
connect a DMX signal terminator.
©Copyright LOTRONIC 2013
COMMON
DMX +
INPUT
DMX‐
SPOT60LED
Resistance 120 ohm
1/ 4w between pin 2
(DMX‐) and pin 3
(DMX+) of the last
fixture.
Page 3