afx light SPOT 60 LED Manuel D'utilisation page 6

‐ SPECIAL ( You can check serial number, Load the factory parameters, .... )
o BLACKD ( To set the moving head in blackout mode )
o DMXERR
o SERIAL ( To show the serial number in LCD display )
o FACTORY ( To load the factory parameters ). The password is 0000
‐ GENERAL ( To set the DMX address, to choose the DMX operate mode, to adjust mic sensitivity, to set Pan
and TILT,... )
o ADDRESS ( To set the DMX address from 001 to 512 )
o PERSON ( To choose DMX operate mode : 11 DMX channel or 14 DMX channels )
Note : Only 14 Channels operating mode is ok. No change if you select 11 channels
o INVERT ( To invert PAN and TILT moves )
o LCD DISPLAY ( To choose if the LCD always lights on or lights off after 60s )
o SOUND ( To set the sound mic sensitivity )
o DEFAULT ( To reset parameters )
AUTO RUN MODE
One of two Auto Run Sub‐modes can be selected with a choice of preset speeds .This mode enables the unit to act as
a Master to other Slave units
Choosing Auto Run Sub‐modes
Press the "MENU" button to display "RUN". Press ENTER than use "UP" and "DOWN" buttons to select AUTO1 or
AUTO 2
Initial LED Display
RUN
RUN
SOUND ACTIVATED MODE
The unit responds to sounds picked up by the built‐in microphone to create a light show. The sound changes the
color and the position of the effect. This mode enables the unit to act a Master to other Slave units
Selection of Sound Activated mode
Press the "MENU" button and choose "RUN". When the "ENTER" button is pressed the LED Display changes to
"SOUND" and the unit enters Sound Activated Mode.
Initial LED Display
RUN
©Copyright LOTRONIC 2013
Second LED Display
AUTO1
AUTO2
Second LED Display
SOUND
SPOT60LED
Sub‐mode
Auto mode 1
Auto mode 2
Sub‐mode
Sound Activated
Page 6