Calibrating Parallel Beams - Elkron EL250RT Notice D'installation Et D'utilisation

Note: When the alignment of a transmitter is being tested, the other TX optics not set to test TX are automatically
switched off.
BE CAREFUL WITH BARRIERS ON THE SAME LINE OF SIGHT. IF NECESSARY, DISCONNECT THE POWER OF
THOSE THAT INTERFERE DURING CALIBRATION.
62

13 CALIBRATING PARALLEL BEAMS

RX1
RX2
RX3
RX4
TX1
TX2
TX3
TX4
EL250RT
Set the TX1 and RX1 optics for
testing and perform the
calibration as explained in the
previous section.
Set the TX2 and RX2 for
testing and perform the
calibration.
Set the TX3 and RX3 for
testing and perform the
calibration.
Set the TX4 and RX4 for
testing and perform the
calibration.