Setting The Receiver Optics - Elkron EL250RT Notice D'installation Et D'utilisation

11.2 SETTING THE RECEIVER OPTICS

J4 TEST POINT
WEAK SIGNAL LED
J4 TEST POINT  The signal can be measured in Volts by placing a tester on the J4 test point. CONSULT ELKRON
TECHNICAL SUPPORT REGARDING ITS USE.
J3 TAMPER  Connection for an additional external tamper for the barrier.

DIP SWITCHES ON A COLUMN WITH 4 RECEIVERS
With DIP 7 set to ON (default setting), the power supply LED lights up to verify the functioning of the RX optics.
Note: The dip switches are set in the factory and should not be changed. For special configurations, you are
advised to contact Elkron technical support.
1 2 3 4 5 6 7
RX4
RX3
RX2
RX1
EL250RT
1 2 3 4 5 6
J3 TAMPER
57