Calibration And Alignment; Calibration Through The Optical Filter - Elkron EL250RT Notice D'installation Et D'utilisation

Once the barriers are installed, for correct alignment, point the optical units of the transmitters and the receivers towards
each other, adjusting the lens-holders horizontally by moving them manually and vertically using the screws on the front,
above the lens.
Vertical positioning
Note: Tighten the joint release screw after making the adjustment

12.1 CALIBRATION THROUGH THE OPTICAL FILTER

The calibration can be improved using the supplied filter:
Place the filter in front of the TRANSMITTER optics to be aligned.
We recommend calibration using the filter on long distances and then seeking
the maximum signal.
 Place the filter in front of the TRANSMITTER optics to be aligned.
Note: Calibration using the filter is recommended over long distances to
seek the maximum signal.
It is sufficient to use the filter on the TX only, with no need to repeat the
operation on the RX.

12 CALIBRATION AND ALIGNMENT

Horizontal positioning
EL250RT
JOINT RELEASE
SCREW
OPTICAL
FILTER
59