Baxi Luna HT 1.450 Notice D'installation Et D'entretien page 25

4.1.4 flue terminal location
= VENT TERMINAL
Fig. 18
A = 12"
B = 12"
C = 12"
D = 18"
E = 18"
F = 9"
G = 6"
H = 4 ft. (U.S.A.)
3 ft. (Canada)
I = 3 ft. (U.S.A.)
6 ft. (Canada)
J = 9" (U.S.A.)
12" (Canada)
K = 3 ft. (U.S.A.)
6 ft. (Canada)
* L = 7 ft.
** M = 18"
* a vent shall not terminate directly above a side-walk or paved driveway which is located between two single family
dwellings and serves both dwellings unless terminated 7 ft above sidewalk.
** only permitted if veranda, porch, deck or balcony is fully open on a minimum of 1 side beneath the floor.
Note:
local Codes or Regulations may require different clearances.
The flue terminal must be exposed to the external air and the position must allow the free passage of air across it at all
times. In certain weather conditions the terminal may emit a plume of steam. Avoid positioning the terminal where this
may cause a nuisance.
INSTALLATION AND SERVICING INSTRUCTIONS
= AIR SUPPLY INLET
Vent Termination Minimum Clearances
clearances above grade, veranda, porch, deck or balcony
clearances to window or door that may be opened
clearance to permanently closed window
vertical clearance to ventilated soffit located above the terminal within a horizonta-
distance of 2 feet (60 cm) from the centre line of the terminal
clearance to unventilated soffit
clearance to outside corner
clearance to inside corner
not to be installed above a gas meter/regulator assembly within H horizontally from
the centre line of the regulator
clearance to service regulator vent outlet
clearance to non-mechanical air supply inlet to building or the combustion air inlet
to any other appliance
clearance to a mechanical air supply inlet
clearance above paved side-walk or a paved driveway located on public property
clearance under veranda, porch, deck or balcony
25
= AREA WHERE TERMINAL
IS NOT PERMITTED
7110242.02 - en