stayer SCC255 Instructions D'emploi page 13

Preparation for working with the upper table.
1. Begin with the head raised and set at 0º, and the cable
unplugged.
2. Place the lower protector 2 adjusting it perfectly.
3. Lower the head and hold it, inserting the knob 4.
If the protector is not in place, the machine will not work.
Cutting guide
The equipment may include a guide for cuts at fixed me-
asurements and with angles. It is installed, fastening it to
the slots of the upper table.
Cutting
1. Start it up with lock.
2. Bring the piece with maximum care to the cutting
disc, keeping your hands away from the route of
the cut.
3. Make the cut by pushing the piece with an intensity ad-
justed to the characteristics of the material.
13. Extraction of dust
The machine comes prepared for the vacuuming of parti-
cles generated in the cutting with an outlet in the back part
of the head.
The supplied bag can be used or coupled to a vacuum
with the supplied adaptor.
14. Regular Cleaning, maintenance and
greasing
14.1 Mantenimiento y limpieza
WARNING!
Take off the plug before performing any adjustment or
maintenance comeback.
Cleaning
Clean the machine starting with a brush or with a flat brush
so as to remove sawdust and with a soft cloth. If compres-
sed air is available, complete cleaning by blowing with the
compressed air pistol.
Maintenance
After each 2,000 hours of use or each two years the elec-
trical tool must be sent to the official technical service for
maintenance and complete revision.
Before each use, check nuts and joints to detect any vi-
bration issues and use. If there are gaps take the machine
to service.
Except squeeze and brush change, the machine does not
require any special maintenance by the user. Keep the
machine clean and use it correctly. Regularly have the
correctness of the adjustments checked by a sufficiently
trained user. In the case of any failure, contact our tech-
nical service.
ENGLISH
13
Greasing
This machine does not require any specific greasing by
the user. Specific greasing of the electrical tool will be ca-
rried out on the occasion of the regular maintenance revi-
sions at the official technical service.
If despite the careful process of manufacturing and con-
trol, the electric tool breaks down, the repair should be
assigned to an authorized service technician for STAYER
electric tools.
For any consultation or request for replacement parts it is
essential that you indicate the article number that appears
on the plate of characteristics of the electric tool.
14.2 Repair service of the manufacturer or
commercial agent:
Stayer Ibérica S.A.
Área Empresarial de Andalucía - Sector 1
C/ Sierra de Cazorla, 7. CP.28320
Pinto (Madrid) Spain.
15. Warrantee
Warrantee card
You will find the warrantee card among the documents
belonging to the tool. You must fill in the warrantee card
completely and attach a copy of the purchase ticket or
invoice thereto, and give it to your distributor against the
corresponding acknowledgement of receipt.
Should this card be lacking, immediately re-
Observation!
quest your distributor to furnish it.
The warrantee is limited solely to manufacturing or me-
chanization failures, and it ceases to exist when parts
thereof have been disassembled, manipulated or repaired
out of the manufacturing plant.
16. Disposal
We recommend subjecting electric tools, accessories and
packaging to a recovery process that respect the environ-
ment.
Do not throw away electric tools!
For EU countries only:
In accordance with European Directive
2012/19/UE on unserviceable electric and
electronic apparatus, after transposition into
national law, electric tools must be collected
separately to subject them to ecologic recy-
cling.
Subject to change without notice.
13