stayer SCC255 Instructions D'emploi page 12

10. Fixing for operation
Whenever possible, the workpiece must be fixed in such a
manner that the hand does not intervene. During the cut,
keep the workpiece fixed to the support. ALL MACHINES
ARE PREPARED FOR MOUNTING CLAMPS ALLOWING
FASTENING THE PROFILE IN A SAFE MANNER.
To avoid deformations of the workpieces during fixing the-
reof, the use of wooden profiles being easily applicable to
the movable jaws of the clamps is advised. Clamps can
be easily extracted and leave the working surface totally
clear.
For cutting long workpieces under safe conditions it is es-
sential to hold them with additional supports.
11. Limits regarding the workpiece size
Limits for all models as included in the present manual.
Pag. 4.
12. General instructions for use
Warning!
1. Do NOT use the machine if it is in a bad condition, or
lacks parts including the prescribed upper guards (the
illustrations of the present manual may be used as an
orientative guide). Unplug it, remove it from the working
area and immediately send it to an authorized technical
service.
2. Know and comply with all safety measures before you
start the machine.
- Obligatory used of aspiration particle system when cut-
ting the wood.
Starting and stopping the machine
Warning!
1. The machine is provided with a locking button for star-
ting allowing the motor to run without needing to push the
switch permanently.
2. The equipment is provided with a safety module protec-
ting it against unexpected starts. If, whilst the machine is
running, the supply of electrical power should cease, the
machine will not start after reestablishment thereof. To re-
lease the protection push the starting button twice.
3. Never start with the disc blocked and before beginning
the cut always wait until the cutting disc reaches the maxi-
mum speed.
4. Before stopping the machine, the disc must be cleared
and spinning freely.
Starting with the manual switch
1. Push the power switch to actuate the motor.
Stopping the machine when actuated with the manual
switch
1. Stop pushing switch
ENGLISH
12
Note: Switch for lower table.
Starting with locking
1. Press for a moment the green switch.
Stopping the machine when actuated with locking
1. Press for a moment the red switch.
Note: The locking switch is for the upper table.
Use of the lower cutting table
Warning!
For your safety, you must eliminate contact with the cut-
ting disc through its appearance in the upper table.
Preparation for working with the lower table.
The mandatory requirement is that in the upper table the
teeth of the disc must not remain exposed. Cover the disc
of the upper table with the upper rectangular aluminium
protector. Link the two strapping bands in the back and
front part of the upper table. Ensure the fastening by tigh-
tening the black wing nut for this purpose
WARNING
IF THE PROTECTOR IS NOT INSTALLED, THE MACHI-
NE WILL NOT WORK.
Cutting operation with the lower cutting table
Warning!
1. Respect the limits regarding the size and material of the
workpiece.
2. Use clamps to fasten the workpiece whenever possible.
3. Never lock the motor power switch when working with
the lower cutting table.
Cut
1. Adjust the desired angle with 1 and 8.
2. Start the electrical machine by pushing switch 2. Wait
for some seconds until the cutting disk reaches its maxi-
mum speed.
4. Slowly lower the operating head by a continuous man-
ner and without jerks, using hand grip
USING THE UPPER CUTTING TABLE
Warning!
Before any operation on the upper cutting table, it is man-
datory to adequately prepare the machine. To do this, the
static safety protector 2 is installed in the lower table.
WARNING
IF THE PROTECTOR IS NOT INSTALLED, THE MACHI-
NE WILL NOT WORK.
12