Mi Smart Electric Folding Bike XMDZLZXC01QJ Manuel D'utilisation page 8

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 51
3. Folding the bike
4. Self-discharging precaution
A
B
The phenomenon of running out battery is called self-discharge. If battery is discharged too much,
then deep discharging occurs, which may cause permanent damage to the battery pack. So as not to
decrease the service life of the battery pack, it is recommended to charge it every two months when not
in use. When the battery pack is fully charged, the indicator is staying on green. Unplug the charger from
the power supply before each ride.
5
6
7
C
D
E
Step 1. Pull the seat post upward till you see the minimum
insertion mark, then lock the upper seat clamp (see fig.5).
Step 2. Hold the seat post, lift the rear wheel off the
ground a bit, then rotate the rear wheel forward (see
fig.6) till the magnet on rear wheel touches the frame on
the front. Avoid hitting the kickstand or pedal.
Step 3. Hold the frame with one hand, then loose the
upper seat post clamp and push the seat all the way
down till the bottom of the seat post touches the
ground (see fig.7).
Step 4. To unfold the bike, reverse these steps.
Note: Make sure the upper and lower seat post clamps
are fastened firmly.
A. Charger
B. Indicator
C. Removable Battery Pack
D. Charging Port
E. Plug
6

Publicité

Table des Matières
loading

Produits Connexes pour Mi Smart Electric Folding Bike XMDZLZXC01QJ

Table des Matières