Mi Smart Electric Folding Bike XMDZLZXC01QJ Manuel D'utilisation page 14

• Connect the charger directly to a power source. Never use extension cords.
• Avoid reverse charging.
• If the performance of the batteries decrease substantially, it is time to replace the batteries.
• Keep electrical appliances out of reach from Children or infirm persons. Do not let them use the
appliances without supervision.
• This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved.
• These instructions are also available in an alternative format:
http://www.amc.tech/download/
Riding
• Cycling involves risk of personal injury and damage of the bike, you should assume the responsibility
for that risk. For your safety, please follow the cycling rules with properly using the bike, as well as
regularly carry out the maintenance, which can reduce the risk of injury. This user manual contains
warnings and precautions concerning the consequences of failure to maintain or inspect your bike,
and of failure to follow safe cycling practices.
As with all mechanical components, electric bicycles are subject to wear and high stress. Different
materials and components may react to wear or stress fatigue in different ways. If a component's
service life has passed, it may suddenly fail and cause personal injury. Any cracks, scratches, or
color change in the high-stress areas indicate that the component's service life has passed and
should be replaced. If there was any impact on the bicycle due to a collision, it is recommended to
immediately go to an official dealer for inspection and maintenance. The user may not be able to
see the damage caused by impact on the components made of composite materials, which may
result in a second accident and personal injury.
1. Check the front and rear brakes before use, and adjust them if necessary. The front brake is
controlled by the left brake lever and the rear brake is controlled by the right brake lever. After
properly adjusting the brakes, the bicycle should brake reliably when pulling both the left and the
right brake lever halfway. When the brake pads are worn excessively, they must be replaced in time.
2. Check whether the chain is properly lubricated before using the bicycle. Turn the pedal by hand
and check whether the chain links move smoothly and are corrosion-free. If the chain is corrosive
or frozen, add an appropriate amount of lubricant, or replace the chain if necessary.
3. Before riding the bicycle, check the tire pressure, the handle bar movement, the rotation of the
front and rear wheel, the electrical circuit, the battery level and the working condition of the motor,
as well as the lights, bell, and fasteners.
(1) Low tire pressure will increase the friction between the tire and the road surface. This will
increase the tire's wear and thus reduce its total mileage. It will also negatively affect the bicycle's
handling and steering, and thereby reducing comfort and safety. If the tire pressure is too low,
immediately inflate the tires. The recommended tire pressure is 35–45 PSI.
(2) If the handle bar is stuck or does not turn smoothly, it should be adjusted or lubricated in time.
Use calcium-based or lithium-based grease as a lubricant. First loosen the front fork's locknut, then
turn the front fork's upper block. Once it is adjusted as preferred, tighten the front fork's locknut.
(3) If the front and rear wheel do not rotate smoothly due to friction, the bicycle's power
consumption will increase and its mileage will reduce. To prevent failure, make sure the bicycle
is lubricated and maintained in a timely manner. Use calcium-based or lithium-based grease as a
lubricant. If the hub fails, replace the bearings or the complete hub. If the motor fails, it must be
repaired by an authorized dealer.
(4) Power on the bicycle when checking the electrical circuit for continuity. Check whether all
connectors are firmly plugged in and all fuses are working normally. In particular, check whether the
12