Positioning Projector; Adjustable Feet - Sanyo PLC-SE10 Mode D'emploi

G This projector is designed to project on a flat projection surface.
G The projector can be focused from 5.3'(1.6m) ~ 40.0'(12.2m).
G Refer to the figure below to adjust a screen size.
5.3' (1.6m)
31"
31"
Screen Size
(W x H) mm
629.9 x 472.4
Height (H1)
16.7"(425.16mm)
Height (H2) 1.9"(47.24mm)
Picture tilt and projection angle can be adjusted by rotating
ADJUSTABLE FEET. Projection angle can be adjusted to 15.6
degrees.
1 Lift the front of a projector and pull FEET LOCK LATCHES
on the both sides of a projector.
2 Release FEET LOCK LATCHES to lock ADJUSTABLE FEET
and rotate ADJUSTABLE FEET to fine tune position and tilt.
3 To retract ADJUSTABLE FEET, lift the front of a projector
and pull and undo FEET LOCK LATCHES.
Keystone distortion of a projected image can be adjusted by
Menu Operation. (Refer to P20 and 35.)
CAUTION
Avoid positioning a projector with the angle of more than 20
degrees. Projection Lamp may malfunction.

POSITIONING PROJECTOR

20.0' (6.1m)
13.1' (4.0m)
100"
77"
40"
40"
812.8 x 609.6 2032 x 1524
21.6"(548.64mm) 54"(1371.6mm)
2.4"(60.96mm) 6"(152.4mm)

ADJUSTABLE FEET

ROOM LIGHT
The brightness in a room has a great influence on
picture quality. It is recommended to limit
ambient lighting in order to provide the best
image.
26.6' (8.1m)
200"
150"
153"
115"
100" 150"
3048 x 2286
81"(2057.4mm)
9"(228.6mm)
ADJUSTABLE FEET
PREPARATION
40.0' (12.2m)
300"
Max. Zoom
230"
Min. Zoom
200" 300"
4064 x 3048 6096 x 4572
108"(2743.2mm) 162"(4114.8mm)
12"(304.8mm) 18"(457.2mm)
FEET LOCK
LATCHES
H1
H2
9