WALTHER PILOT PILOT TWIN Instructions De Service page 11

Table of contents
Exploded Drawing
Declaration of CE-Conformity
Spare Parts List
1 General
1.1 Model identification
1.2 Intended use
1.3 Inappropriate use
2 Technical description
3 Safety instructions
3.1 Identification of safety instructions
3.2 General Safety instructions
4 Assembly
4.1 Supply line connection
5 Operation
5.1 Start-up and shut-down
6 Spray pattern adjustments
6.1 Correcting spray pattern flaws
7 Retooling and repairs
7.1 Replacement of the material nozzle and the air cap
7.2 Replacement of the material needle
7.3 Replacement of the defective needle packing
8 Cleaning and service
9 Trouble shooting
10 Disposal of cleaning and servicing substances
11 Technical data
2
21
22
24
24
24
25
25
25
25
26
27
27
27
27
28
29
29
29
30
30
30
31
32
32
20
Declaration of CE-Conformity
We, the manufacturers of the equipment, hereby declare under our sole respon-
sibility that the product(s) described below conform to the essential safety requirements.
This declaration will be rendered invalid if any changes are made to the equipment wit-
hout prior consultation with us.
Manufacturer WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Tel.: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Type Designation
Release Agent - Manual Spray Gun
PILOT TWIN
Intended purpose Processing of sprayable media
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006 / 42 / EC
94 / 9 EC (ATEX Directives)
EN ISO 12100-1
EN ISO 12100-2
DIN EN 1127-1
Specification according 94 / 9 / EC
Category 2 Part marking
Authorized with the compilation of the technical file:
Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30
D- 42327 Wuppertal
Special remarks :
The named product is intended for installation in other equipment. Commissioning is
prohibited until such time as the end product has been proved to conform to the pro-
vision of the Directives 2006 / 42 / EC.
Wuppertal, the 1st of January 2010
i.V.
Name: Torsten Bröker
Position: Manager, Design and Development
This Declaration does not give assurance of properties in the sense of product liability. The safety
instructions provided in the product documentation must be observed at all times.
V 11 530
DIN EN 1953
DIN EN 13463-1
Tech.File,Ref.:
II 2 G c T 6
2414
21