Replacing The Lamp; Troubleshooting - Zanussi ZOP27901XE Notice D'utilisation

from the top panel. Make sure the glass slides
out of the supports completely.
Clean the glass panels with water and soap.
Dry the glass panels carefully.
When the cleaning is completed, install the
glass panels and the oven door. Do the above
steps in the opposite sequence.
Make sure that you put the glass panels (A and
B) back in the correct sequence. The middle
panel (B) has a decorative frame. The screen-
printing zone must face the inner side of the
door. Make sure that after the installation the
surface of the glass panel frame (B) on the
screen-printing zones is not rough when you
touch it.
A B
Make sure that you install the middle panel of
glass in the seats correctly.

Troubleshooting

WARNING!
Refer to Safety chapters.
What to do if...
Problem
You cannot activate or operate
the oven.
www.zanussi.com

Replacing the lamp

Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
The back lamp
1. Turn the lamp glass cover counterclockwise
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
4. Install the glass cover.
Possible cause
The oven is not connected to an
electrical supply or it is connec-
ted incorrectly.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
deactivate the circuit breaker.
to remove it.
heat-resistant lamp.
Check if the oven is correctly
connected to the electrical sup-
ply (refer to the connection dia-
gram if available).
A
B
Remedy
21