Dismantling And Disposal - ProMinent DULCO Trans 40/1000 PP Mode D'emploi

Cleaning, Measures after use, Dismantling / DIsposal
Cleaning after each operation
 Clean the pump by flushing an appropriate cleaning agent.
First pump the cleaning agent in circuit, then rinse with
clean detergent.
 Do not remove motor from the pump as long as there is
any back pressure.
 Before removing the motor from the pump, completely
drain pump, flexible hose and fittings.
 Do not use flammable liquids to clean the pump.
 The pump and hose must be compatible with
the cleaning agent.
 The pump should not be immersed deeper into
the cleaning agent than the outlet connection.
Dismantling of pump for cleaning :
1. Remove the plug.
2. Release union nut between motor and pump.
3. Remove the motor.
4. Remove inner tube from the pump.
Measures after use
Attention!
 Empty pump, hose and fittings after every use.
 Drain hand nozzle after use. Otherwise liquid being
contained within the outlet tube will flow out without control.

Dismantling and Disposal

 Pump, hose and fittings must be emptied prior to dismantling.
 Prior to dismantling the outlet tube switch the pump off and
disconnect the mains.
 Collect environmentally harmful substances and liquids in
appropriate containers and dispose of them in an environmen-
tally sound manner.
 Dispose of scrap material and parts that cannot be repaired or
reused in an environmentally sound manner.
Testing / Repair
Testing / Repair
 Regulary check the pump according to the relevant national
safety instruction and/or rules for prevention of accidents
(in Germany these are e.g. BGV A3).
 Repairs should only be carried out by the manufacturer
or an authorized repair shop.
Note
 Depressurise the system.
Separate pump from current.
Empty hose and hand nozzle.
 Always replace defective parts.
Only use genuine spare parts.
 There must be at least 6 balls in the swivel joint.
Replacement of hose connector and / or seal:
1. Take off the safety lever (screw out safety screw)
2. Take out the balls off the swivel joint (maybe with the help of a
magnet pin)
18 19
Ball
Seal
Hose connector
Safety screw
Safety lever