Initial Commissioning - Honeywell KaltecSoft Notice D'installation

General safety:
The rated mains power (see technical data) and the requisite
inlet water pressure must be present at all times.
No protection against a lack of water is provided.
This must be installed on-site if required.
Overpressure and fluctuation protection:
Attention: Water pressure must never exceed the unit's
maximum 8.0 bar.
If the network water-pressure is higher than 6.0 bar (or you
are unsure about pressure), a pressure reducer (pressure
reducing valve) must be installed upstream of the unit.
During pressure fluctuations or surges, the sum of the
pressure surge and the standing pressure is not to exceed the
nominal pressure.
Electrical interfaces:
The emission of interference (EMI = voltage peaks, high-
frequency electromagnetic fields, interference voltages,
voltage fluctuations...) by the surrounding electrical systems
may not exceed the maximum values specified in EN 61000-
6-3.
Data analysis of the hard water in your area:
Continuous operation of the water softener with water
containing chlorine or chlorine dioxide is possible if the
concentration of free chlorine/chlorine dioxide does not
exceed 0.5 mg/l. The type of pre-treatment must be
determined individually.
Principle of intelligent regeneration:
The unit should be sized according your current water
consumption.If water consumption is reduced, e.g. during
holidays, the softener should be isolated and bypassed
during this period of inactivity.
When reinstating operation after a period of inactivity a shut-
off device must be fully opened for at least 5 minutes before
water can be used again.
Inlet and outlet connections:
When installing the unit, select a location where the unit can
easily be connected to the water supply network.
A connection to the waste water system (at least DN 50), a
floor drain and a separate mains socket (see technical data)
must be nearby.
Overflow hose connection:
A suitable overflow hose connection is required to remove the
waste water.
Exclusion of warranty:
Non-compliance with the installation conditions and the
operator responsibilities voids the warranty.
Honeywell GmbH
GB
Guarantee:
In the event of a malfunction of the unit during the guarantee
period, please contact your aftersales service department
and quote the model type and the production number (see
technical data or the rating plate on unit).
Note: Only your local after-sales service staff may perform any
works under the guarantee. Any work performed by a
third party must be directly commissioned by your
aftersales service.

3.2 Initial commissioning

For professional installation by a qualified fitter.
• Has all packaging material (C) (see figure below) been
removed from the brine cabinet?
• Is there a protective filter upstream from the unit in the
immediate vicinity?
• Is the water and power supply to the unit continuous
(water network pressure of at least 1 bar)
• Have you opened the pressure reducing valve to the
limit stop?
• Have the water hoses been properly connected?
• (Observe the flow direction arrows on the multiblock
and on the device). Have the drain water hose and the
overflow been routed separately to the waste water
system and connected? (See Installation Guidelines)
• Have you informed the operator of the inspection
schedule? (Check supply of salt and hardness of
blended water (downstream from the device) at least
every two months)
• Have you informed the operator of the maintenance
schedule? (Tasks in accordance with manufacturer's
instructions. Interval annually)
Please check connections and pipeline junctions for leaks.
Handing over the unit to the operator:
If there is a delay between the installation/start-up of the unit
and transfer to the operator, a manual regeneration must be
performed.The operator must be told how the unit works as
well as how to operate and inspect it.
Ensure that the operator receives the installation and
operating manual.
6 MU0H-1420 GE23 R0618