Description Of Function; Functions And Features - Honeywell KaltecSoft Notice D'installation

KaltecSoft
4

Description of Function

4.1 Functions and features

Capacity requirement-dependent of the unit
controller:
The unit operates according to the principle of intelligent
regeneration.
The average capacity level of each model is preset and
updates automatically to the actual consumption within 7
days.
The presetting is appropriate for the most common
applications.
It is not necessary to adjust the unit for individual
requirements.
Intelligent quantity-dependent
regeneration:
When the unit is started, the available supply of softened
water is programmed (depending on the hardness of the
water).
At a user-defined time (e.g. at night), the unit checks whether
the remaining supply of softened water is sufficient for the
following day.
If this is not the case, the softening column is regenerated by
only the exact percentage necessary to fully replenish the
supply of softened water to 100 %.
Note: With intelligent regeneration, the remaining supply of
softened water is not wasted.
This intelligent regeneration method is possible because of
the precision flowmeter, which is able to adjust the amount of
brine required for partial regeneration.
The consumption of regenerative and water is reduced to the
required minimum.
In the event of a power failure, the data and the time are
retained (for a limited amount of time).
Options:
Disinfection
The unit is optionally equipped with a device that disinfects
the ion exchange resin during the regeneration (KS30I-xx).
Salt type
Use only salt tablets acc. EN 973.
MU0H-1420 GE23 R0618
GB
Lift off this cover and connect the
jack plug of the lead to the
control box behind the front panel
11
4.2 Operation
Charge Bar:
Having set the display on the control facia, you will notice that
during normal operation there is a charge bar running along
the bottom of the display.
This charge bar shows the percentage of water softener
capacity remaining since the last regeneration.
Immediately following a regeneration, the charge bar returns
to 100 %.
Resetting the display during operation:
If the time (or any other user setting) is to be adjusted during
normal operation, press any key to illuminate the display,
press the [SET] key once.
The display will flash and indicate present time.
Using the keys will alter the time as described in chapter 2.2
Standard settings.
Power loss:
The AMECS system will maintain the individual programming
parameters of the water softener for a few hours.
If the power cut lasts longer than a few hours, the control will
flash "00:00" when power is returned to the control.
The unit will continue to keep time from the moment power is
restored.
In this situation the time of day will need to be reset.
Flow indicator:
During normal operation, a flow indicator will flash on the
display at a rate of one litre per pulse when water is passing
through the softener.
Cleaning:
Your water softener may be cleaned using a damp cloth and
a mild detergent.
Do not use bleaches, solvents or spirits as they may damage
the surfaces.
Manual regeneration [recharge] button:
Under normal operating conditions your water softener will
regenerate automatically and you should not normally have to
regenerate the unit manually.
If however a manual regeneration is required then follow the
procedure set out below.
1. Press any key to illuminate the display
2. Momentarily pressing the recharge button (symbol
underneath the display and furthest to the right) will
illuminate Recharge Tonight on the display and perform
a regeneration at 2.00 a.m. regardless of the remaining
water softener capacity
3. If the recharge button is subsequently pressed, this will
clear the Recharge Tonight indicator from the display
and cancel the Recharge Tonight feature
4. If the recharge button is pressed down for six seconds,
the controller will flash the Recharge display and
immediately commence the regeneration cycle which
cannot be cancelled
Honeywell GmbH