Dimensions - Honeywell KaltecSoft Notice D'installation

Checklist
Problem: Water runs from the drain constantly.
Is the unit in recharge mode?
Is the power on?
Problem: Excessive salt usage.
Check the hardness setting.
Problem: Electronic Display.
The display shows error code: "Err 1", audible alarm
sounds, (see note below).
Is the digital display blank?
Problem: Unit regenerates at the wrong time.
Is the present time correct?
If the home position is not detected within 10 minutes,
the main display will show an "Err 1" message to
indicate a controller error and an audible alarm will
sound. The error condition can only be cleared by
removing and re-applying the power.
7

Dimensions

Overview
Note: All dimensions in mm unless stated otherwise.
Honeywell GmbH
GB
Solution
If yes, this is normal, wait until the recharge is complete. 5
There should be no flow to drain in the service position. 6
Reduce the hardness if incorrect.
Check all the connections are secure. Turn the power off
for 10 seconds then turn back on, allow the system to
reset.
Check the power is turned on and all the connections
are secure.
Reset the present time.
CAUTION!
If problem persists, please call your local dealer or
after sales service team.
14
Page
5, 12
11
5
MU0H-1420 GE23 R0618