Auxiliary Audio Equipment - Sony MEX-R1 Mode D'emploi

Location of controls
The corresponding buttons on the rotary
commander control the same functions as those
on the main unit or the card remote commander.
SOUND
PRESET/
DISC
SOURCE
VOL
The following controls on the rotary commander
require a different operation from the main unit
or the card remote commander.
• PRESET/DISC control
To select preset stations; control CD, the same
as (3)/(4) (ALBM –/+) on the main unit or M/
m on the card remote commander (push in and
rotate).
• VOL (volume) control
The same as the volume +/– buttons (rotate).
• SEEK/AMS control
The same as (SEEK) +/– on the main unit or
./> on the card remote commander
(rotate, or rotate and hold).
Changing the operative direction
The operative direction of the controls is factory-
set as shown below.
To increase
If you need to mount the rotary commander on
the right hand side of the steering column, you
can reverse the operative direction.
While pushing the VOL control, press
and hold (SOUND).
Tip
You can also change the operative direction of these
controls in the menu (page 36).
38
ATT
MODE
DSPL
SEEK/AMS OFF
To decrease

Auxiliary audio equipment

You can connect optional Sony portable devices
to the BUS AUDIO IN/AUX IN terminal on the
unit. If the changer or other device is not
connected to the terminal, the unit allows you to
listen to the portable device on your car speakers.
Note
When connecting a portable device, be sure BUS
CONTROL IN is not connected. If a device is
connected to BUS CONTROL IN, "AUX" cannot be
selected with (SRC) (SOURCE).
Tip
When connecting both a portable device and a
changer, use the optional AUX-IN selector.
Selecting auxiliary equipment
Press (SRC) (SOURCE) repeatedly
until "AUX" appears.
Operate by the portable device itself.
To adjust the volume level of auxiliary
equipment, see "AUX LVL" on page 36.