Condensate Drains - Dometic MCS5 Notice De Montage

_IA_MCS.book Seite 17 Mittwoch, 28. Januar 2009 9:06 09
MCS5, MCS15
Unit dimensions (fig. 2, page 3)
Unit Capacity
A – Duct Size
B – Base Depth
C – Overall Depth
D – Width
E – Height
8.2

Condensate Drains

d Warning!
Do not terminate condensate drain line
– within 0.9 m of any outlet of engine or generator exhaust systems,
– in a compartment housing of an engine or generator,
– in a bilge, unless the drain is connected properly to a sealed
Failure to comply may allow bilge or engine room vapors to mix with the
air conditioners return-air and contaminate living areas which may result
in injury or death.
The following guidelines should be followed during the installation of the
condensate drains:
For installation of the condensate drain (fig. 3, page 4):
I: Top view
II: Side view
III: Back view
condensate or shower sump pump.
Do not route condensate drains to the bilge.
Run the condensate drain line downward from the unit to a suitable
drain location.
The condensate drain line should have a trap.
Remove the aft facing watertight plug from the base pan (4) of the air
conditioning unit.
Slip the solid washer (2) and the liquid-seal washer (3) onto the PVC
fitting (1) in that order.
Connect the PVC fitting (1) through the exposed hole in the base
pan (4) with the locking nut (5).
Securely tighten with two wrenches to provide a proper seal.
Attach a 5/8 (16 mm) I.D. reinforced hose to the hose barb and
"
secure with stainless steel hose clamps.
MCS5 MCS15
mm mm
102 153
204 254
229 268
407 559
286 343
Installation
17