Arbour Installation - Jet JWS-34KX Mode D'emploi

At the lower spindle speeds and at smaller tool diameters an
increased risk of workpiece kickback exists.
The maximum permissible speed (rpm, /min, min
on each tool may never be exceeded.
Router bits may only be operated in the highest spindle
speed (8000 rpm).
The sanding spindle may only be operated in the lowes
spindle speed (1700 rpm).
The speed is set by changing the V-belt location on the
pulleys (Fig 7).
Speed range:
1700, 3500, 6000, 8000 RPM
The chosen spindle speed can be seen on the viewing
window.

7.2 Arbour installation

The arbour is mounted to the machine spindle with the draw
bar and nut.
Use the following procedure to install the arbour.
Disconnect the machine from the power source (pull mains
plug).
Engage the spindle rotation lock.
Pull plunger and rotate 90° (Fig 8).
Fig 6
-1
) marked
Fig 7
Remove all table insert rings.
Clean the arbour shank and spindle bore (T, Fig 9).
1) Install the arbour nut (N, Fig 10) to the machine spindle.
Keep approx. 2 turns (4mm) distance to the end of spindle
nose thread.
2) Place the arbour (A, Fig 11) into the spindle and thread
arbour onto the nut (N).
Slightly tighten the nut.
Fig 8
Fig 9
Fig 10