Trouble Shooting; Environmental Protection; Available Accessories; Safe Operation - Jet JWS-34KX Mode D'emploi

9. Trouble shooting

Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or power cord-
consult an electrician.
*Overload has reacted-
wait 10 min and start again.
*Spindle lock is engaged.
Cutter doesn't come to speed
*Too big or heavy a tool-
choose smaller spindle speed.
*Extension cord too light or too long-use adequate power
supply.
*V-belt excessively tensioned-
apply proper tension.
Wrong spindle direction
*3-phase sequence is wrong-
Push in and rotate phase inverter on 3-phase plug.
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*Cutter head damaged-
replace cutter head immediately.
Cutting surface is bad
*dull cutter-
replace cutter
*Cutter knives blocked by chips-
remove chips.
*Cutting speed too low-
chose correct speed.
*Too heavy a cut-
make several passes.
*knives cutting against grain-
turn workpiece around.
*Workpiece inhomogeneous.
*Moisture content too high.
Snipe
*Inadequate fence board adjustment- use spacer board
where possible.
*Clearance to table hole too big-
use table insert rings.
*insufficient workpiece guiding-
improve hold downs setting.
Spindle quill difficult to adjust
*Lack of lubrication-
lubricate spindle quill
*Quill is clamped.
Poor machining power
*belt is slipping-
tighten belt.
*Resin build up on tables-
clean and wax table surfaces.

10. Environmental protection

Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled. Please leave it at a specialized
institution.
This symbol indicates separate collection for electrical and
electronic equipment required under the WEEE Directive
(Directive 2012/19/EC) and is effective only within the
European Union.

11. Available accessories

Stock number 10000251
30mm spindle arbour incl. spacing collars.
Stock number 10000252
Sanding spindle with drums and sanding sleeves dia. 25, 38,
50, 75, 100mm
-refere to the Jet-Pricelist for various grit sanding sleeves (
see JVOS-10).
Stock number 10000253
Tenoning carriage
Stock number 709207
Foldable roller stand

12. Safe operation

See appendix A (on the last pages of this operating manual).