Content Of Delivery; Machine Description; Transport And Installation; Mains Connection - Jet JDP-22VS Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.3 Content of delivery

Chuck guard with limit switch
Digital speed display
16mm keyless chuck
MT-3 arbor
3 downfeed handles
Drift key
Operating manual
Spare parts list.

4.4 Machine description

Fig 1
A....Drill Head
B....Pulley access cover
C....Operating handle
D....Rack
E....Table locking handle
F.....Table rising handle
G....Drainage plug
H....RPM Readout
I.....Speed select and R/L switch
J.....Column
K.....Work Table
L.....Base
Fig 2
M....Speed adjust handwheel
N....Depth gauge
O....Depth stop fine adjust wheel
P....Chuck guard
Q....Start/Stop buttons
R....E-Stop button
5. Transport and start up

5.1 Transport and installation

The machine will be delivered in a
closed crate.
For transport use a forklift or hand
trolley. Make sure the machine does
not tip or fall off during transport.
The machine is designed to operate in
closed rooms and must be bolted to
the floor.
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
a mild solvent.
Screw handles onto quill down feed
handle rods. Screw handle rods into
hub and tighten (Fig 3).
5
Fig 3
Mounting machine to the floor:
Unbolt the machine from the shipping
crate.
Use heavy duty fibre belt for lifting the
machine off the pallet.
Caution:
The machine is heavy (300 kg)!
Assure the sufficient load capacity and
proper condition of your lifting
devices.
Never step underneath suspended
loads.
Carefully place the machine to the
floor.
Use 4 anchor bolts of sufficient size
and length.
Use a machinist's precision level to
make sure that the machine table is
level.
Loosen mounting bolts, shim and
tighten mounting bolts if needed.
The machine must be level to be
accurate.

5.3 Mains connection

Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
10 A surge-proof fuse.
Only use power cords marked
H07RN-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.

Publicité

Chapitres

Table des Matières
loading

Table des Matières