Sanding Spindle Installation; Tenoning Carriage Installation; Maintenance And Inspection - Jet JWS-34KX Mode D'emploi

Before starting work, check manually that the cutter rotates
freely and that all components are correctly clamped.
At the start of the cut, move the workpiece along the straight
part of the guide plate (F). This way the workpiece enters the
cutter gradually, reaching the maximum depth of cut at the
guide plate mark.
Continue by moving the workpiece, keeping it aligned with the
guide plate mark.
When working complex shapes, make jigs and guides to
guide the workpiece properly and safely.

7.8 Sanding spindle installation

The optionaly available sanding spindle can be mounted in
place of the 30mm spindle arbour.
The sanding spindle may only be installed when the spindle
rotation lock is engaged and the mains plug is pulled.
Sanding sleeves and drums can be chosen between dia. 25,
38, 50, 75 and 100mm.
Cover the clearance zone around the sanding sleeve with
table insert rings.
Install the curved guard body for dust collection (Fig 24).
Attention:
The sanding spindle may only be operated at the lowes
(1700 RPM) spindle speed.
Before starting work, check manually that the sanding spindle
rotates freely and that all components are correctly clamped.
Feed the workpiece straight across the machine table,
holding your fingers close together, guiding the workpiece
with the palm of your hands.
Always keep your hands well clear of the rotating sanding
drum.

7.9 Tenoning carriage installation

The optionaly available tenoning carriage can be placed on
the machine table and is guided in the T-groove.
The wood press (C, Fig 25) and the miter gauge profile (E)
assure the stability of the workpiece.
Fig 24
The covers (D) must be adjusted into proximity of the
workpiece and locked in place.
- workpiece height max 100mm
- workpiece width max 120mm
Adjust the shaper fence to suit the tool diameter used.
The shaper guard (B) should be positioned above the tool.
The vertical press (A) can be lifted to its maximum.
Before starting work, check manually that the cutter rotates
freely and that all components are correctly clamped.
Feed the workpiece by sliding the carriage towards the tool
with both hands pressing the workpiece onto the miter gauge
profile (E).
Always keep your hands well clear of the rotating cutting tool.
Note:
Tenoning work requires power and torque.
In most cases the 3500 RPM spindle speed will perform
best.

8. Maintenance and inspection

General notes:
Maintenance and inspection work may only be carried out
after the machine is protected against accidental starting
by pulling the mains plug.
Clean the machine regularly.
Inspect the proper function of the dust extraction daily.
Defective safety devices must be replaced immediately.
All protective and safety devices must be re-attached
immediately after completed cleaning, maintenance and
inspection work.
Repair and maintenance work on the electrical system may
only be carried out by a qualified electrician.
Drive Belt:
The belt tension must be inspected regularly.
Motor Break:
The motor break works electro-mechanically (break motor).
If breaking time should exceed 10 seconds, the motor break
assembly needs to be replaced (JET Stock Nr.: JWS34-
BME).
Contact your Jet service station immediately.
Fig 25