Curved Guard Installation - Jet JWS-34KX Mode D'emploi

Install the shaper fence body first. To do so, screw the two
bolts into the tapped holes in the machine table.
Set the fence boards approx. 5mm close to the cutter
rotation.
Use the spacer board (A, Fig 19) to securely guide small gibs
.
The spacer board is clampled between the fence boards.
The spacer board is a wear part and a new board needs to be
fabricated if the clearance around the cutter becomes too big.
Have a scrap workpiece available to allow proper positioning
of the fence and the fence guard.
Adjust the fence guard to guide the workpiece and to protect
from accidental cutter contact.
The shaper guard is fastened to the fence cover and can be
opened for tooling and setup access.
Connect the fence to a dust collector.
Before starting work, check manually that the cutter rotates
freely and that fence and guard are correctly clamped.

7.7 Curved guard installation

The curved guard (Fig 20) supplied with the machine can be
mounted to the machine table and allows a maximum tool
diameter of 150mm.
Fig 19
Fig 20
Install the curved guard body first.
The machine table is therefore prepared with a M8 tapped
hole (A, Fig 21) and an 8mm pinhole (P).
Set the height of the guide plate (B, Fig 22) depending on the
position and diameter of the tool and the thickness of the
workpiece. This part guides the wood and must always be
above the cutter.
Use knob (E, Fig 23) to set the chip removal.
Slide the cover (C) down until it touches the part to be
machined.
Connect the dust collector to the curved guard port (K).
Fig 21
Fig 22
Fig 23