Dust Emission; Contents Of Delivery; Transport And Start Up; Transport And Installation - Jet JWS-34KX Mode D'emploi

Acoustic power level
(according to EN ISO 3746):
Idling
Operating
Acoustic pressure level
(according to EN ISO 11202):
Idling
Operating
The specified values are emission levels and are not
necessarily to be seen as safe operating levels. Although
there is a correlation between emission and imission levels,
these do not constitute a basis for determining the necessity
of additional safety measures.
Workplace conditions which could influence the noise
imission level include the duration of resonance, space
particulars, other noise sources etc. For example, the number
of machines and other work being performed. The
permissible workplace levels can vary from country to
country.
This information is intended to allow the user to make a better
estimation of the hazards and risks involved.

4.4 Dust emission

The wood shaper JWS-34KX has been dust emission
inspected.
At an air velocity of 20 m/s on the dust port dia 100mm:
Vacuum pressure
Volume flow
The machine meets the present workplace dust emission limit
of 2 mg/m³.
4.5 Content of delivery
30mm spindle arbour assembly
Collets 8mm and 12mm
Fence assembly
Spacer board for fence
Workpiece hold downs
Push stick
Curved guard assembly
Mitre gauge
Operating tools
Assembly kit
Operating manual
Spare parts list

5. Transport and start up

5.1 Transport and installation

For transport use a forklift or hand trolley. Make sure the
machine does not tip or fall off during transport.
The machine is designed to operate in closed rooms and
must be placed stable on firm and levelled ground.
The machine can be bolted down if required.
For packing reasons the machine is not completely
assembled.

5.2 Assembly

LwA 83 dB(A)
LwA 90 dB(A)
LpA 74 dB(A)
LpA 83 dB(A)
800 Pa
565 m³/h
If you notice any transport damage while unpacking, notify
your supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly manner.
Clean all rust protected surfaces with a mild solvent.
Mount the handle to the hand wheel.
Mount the shaper guard with the two screws supplied (D, Fig
3) to the shaper fence top. To lift the shaper guard push the
handle backwards.

5.3 Mains connection

Mains connection and any extension cords and plugs used
must comply with the information on the machine licence
plate.
The mains connection must have a 16A surge-proof fuse.
Only use extension cords marked H07RN-F, with wires
2
1,5mm or more.
Power cords and plugs must be free from defects.
Connections and repairs to the electrical equipment may only
be carried out by qualified electricians.
ATTENTION:
-Check first if the spindle rotates freely and if all safety
devices are fitted before starting the machine.
Make sure that the spindle is running the correct direction
(counter-clockwise).
- If the direction of rotation is not correct, the phase converter
inside the CCE Euro plug must be pushed in and turned 180°.
(See rotation arrow on machine for correct rotation)

5.4 Dust connection

Before initial operation, the machine must be connected to a
dust extractor. The suction should switch on automatically
when the shaper is switched on.
The flow rate on the suction port must be 20m/sec.
Flexible hoses must be of "non-flammable" quality, and must
be connected to the machine ground system.

5.5 Starting operation

Fig 3