Cutting Tool Installation; Spindle Vertical Travel; Shaper Fence Installation - Jet JWS-34KX Mode D'emploi

Collets supplied with the machine:
- Collet Ø 8 mm
- Collet Ø 12 mm.
To reduce the danger of kick-back and injury.
Only cutting tools marked "MAN" and conforming EN 847-1
respectively
EN 847-2 may be used.
Router bits must be clamped on a shaft length of minimum
20mm.
Tighten the nut (Q).
Cover the clearance zone around the cutter with table insert
rings (A, Fig 18).
Attention:
At the lower spindle speeds and at smaller tool diameters an
increased risk of workpiece kickback exists.
Router bits may only be operated in the highest spindle
speed (8000 rpm).
Disengage the spindle rotation lock.
Set the fence boards approx. 5mm close to the cutter
rotation.
Connect the machine to the power source.
Start the shaper cautiously.

7.4 Cutting tool installation

The cutting tool may only be changed when the spindle
rotation lock is engaged and the mains plug is pulled.
Risk of personal injury by cuts from the cutter knives. Wear
suitable gloves when changing cutters.
Clean all surfaces of cutters and spindle arbourrs with a
suitable solvent (do not use cleaning agents that could
corrode the light metal components).
To reduce the danger of kick-back and injury.
Only cutting tools marked "MAN" and conforming EN 847-1
respectively
EN 847-2 may be used.
Unsuitable, incorrectly mounted, dull, cracked of bent cutter
knives can break or increase the risk of kickback
considerably.
Fig 16
The installation of sanding or polishing tools is not
permissible.
The cutter must be positioned on the arbour as low a possible
(Fig 17.
Watch the sense of rotation (counter clockwise) when
mounting the cutter.
Fill the space between cutter and clamping washer with
spacing collars.
Tighten the tool with the hex nut screw securely. (Don't use a
wrench extension or a hammer to tighten the screw)
Cover the clearance zone around the cutter with table insert
rings (A, Fig 18).
ATTENTION:
Adapt the spindle speed to the cutting tool diameter.
Never exceed the shown numbers of revolution (rpm, /min,
-1
min ) on the tool.
Disengage the spindle rotation lock.
Set the fence boards approx. 5mm close to the cutter
rotation.
Connect the machine to the power source.
Start the machine cautiously.

7.5 Spindle vertical travel

After you loosen the clamping lever the spindle height can be
adjusted with the hand wheel. One revolution corresponds to
a travel of 8mm (2mm for each ¼ turn)

7.6 Shaper fence installation

Fig 17
Fig 18