Dometic CD0050 Instructions De Montage page 15

CD0050, CRD1050
The appliance is designed for ambient temperatures between +18 °C and +43 °C.
In continuous operation, the air humidity may not exceed 90 %.
Set up the fridge in a dry, sheltered place. Avoid placing it near heat sources such as
radiators, gas ovens, hot water pipes etc. Do not let it stand in direct, strong sunlight.
Install the refrigerator so that the warm air produced can easily flow away (either
upwards or to the sides). Therefore make sure there is adequate ventilation (fig. 3,
page 4).
No. in
fig. 3, page 4
1
2
3
4
The condensation which forms during normal operation of the refrigerator can be
drained off via two outlets on the appliance. For delivery purposes, these outlets are
sealed. The two outlets are located on the rear and on the underside of the appliance
(fig. 4, page 4).
➤ Choose the condensation outlet most suitable for the place of installation and
remove its cap.
➤ Insert a sharp object (e.g. a screwdriver) approx. 25 to 30 mm into the outlet to
pierce open the inside of the appliance.
If you put the refrigerator in a recess, you can fix it inside with suitable screws:
➤ Remove the blanking plugs (fig. 5 2, page 5).
➤ Push the refrigerator into the recess.
➤ Use suitable screws (fig. 5 1, page 5) to fix the refrigerator in place.
➤ Press the blanking plugs (fig. 5 2, page 5) into the openings.
EN
Explanation
Cold intake air
Hot waste air
Condenser
Spacing above the fridge if insufficient air can circulate above or at
the side.
Installing and connecting the refrigerator
15