Dometic CD0050 Instructions De Montage page 17

CD0050, CRD1050
➤ Connect the refrigerator
– as directly as possible to the poles of the battery or
– to a 12 Vg socket or 24 Vg socket.
Fit a fuse in the positive wire of 15 A (for 12 V) or 7.5 A (for 24 V) (fig. 8 1,
page 6).
➤ Connect the red cable (fig. 8 rt, page 6) to the positive terminal of the battery.
➤ Connect the black cable (fig. 8 sw, page 6) to the negative terminal of the
battery.
A
NOTICE!
Disconnect the refrigerator and other electric loads from the battery
before connecting the battery to a quick charging device.
Overvoltage can damage the appliance electronics.
For safety reasons the refrigerator is equipped with an electronic system to prevent
the polarity being reversed. This protects the refrigerator against reversed polarity
when connecting to a battery and against short circuiting. To protect the battery, the
refrigerator switches off automatically if the voltage is insufficient (see table below).
Cut-off voltage
Cut-in voltage
Connecting the refrigerator to AC power (accessory)
You can connect the refrigerator to AC power if you use a rectifier.
D
DANGER!
• Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
• If you are operating your refrigerator on board a boat with a mains
connection of 230 V from the land, you must install a residual current
circuit breaker between the 230 V mains supply and the refrigerator.
Seek advice from a trained technician.
I
NOTE
Always connect the refrigerator to the rectifier. Otherwise the priority
circuit for the refrigerator will be disabled.
The priority circuit reduces the load on a connected battery by the
rectifier always switching to mains operation if AC power is connected.
EN
Installing and connecting the refrigerator
12 V
10.4 V
11.7 V
24 V
22.8 V
24.2 V
17