Use; Fitting A Socket; Switching On/Off; Setting The Torque - Parkside PDSS 310 B5 Traduction Des Instructions D'origine

Use

Fitting a socket

WARNING! RISK OF INJURY!
► Disconnect the compressed air supply before
working on the tool .
♦ Push one of the supplied sockets 6 and/or the
extension attachment 7 onto the square socket
bit holder 1 .

Switching on/off

Switching on
♦ Press the trigger 5 to switch the tool on .
Switching off
♦ Release the trigger 5 .
♦ When you have finished working, disconnect
the tool from the compressed air source .

Setting the torque

♦ Press the torque control 4 and set the desired
torque range by turning it . Click the desired
level into place at the ◄ marker .
NOTE
► The torques which can be achieved depend
on the compressed air system installed .
Setting Torque
1 weak/minimum
2 normal
3 strong
4 very strong/maximum
PDSS 310 B5

Changing the direction of rotation

WARNING!
► The rotation direction switch 2 may only be
used/adjusted when the tool is at a standstill .
♦ Press the rotation direction switch 2 in the
direction "F" (Fasten) to set the clockwise rotation
mode . You can use this mode to tighten nuts, for
example .
♦ Press the rotation direction switch 2 in the
direction "R" (Release) to set the anticlockwise
rotation mode . You can use this mode to un-
fasten nuts, for example .

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the tool from the
compressed air supply.
CAUTION!
► Before carrying out maintenance, clean off
any hazardous substances that may (due to
working processes) have accumulated on
the tool . Avoid all skin contact with these
substances . If the skin comes into contact
with hazardous dusts, this can lead to severe
dermatitis . If dust is produced or swirled up
during maintenance, it can be inhaled .
NOTE
► To ensure correct functioning and long-term
durability of the tool, pay attention to the
following points:
■ Sufficient and continuous oil lubrication is highly
important for optimum functionality .
■ Check the speed and vibration levels after each use .
■ If the tool is exhibiting excessive vibration levels,
the cause of the vibrations must be identified
and dealt with .
■ Use only the genuine replacement parts rec-
ommended by the manufacturer, otherwise you
could put users at risk . In doubt, contact the
Service Centre .
■ Clean the tool with a soft, dry cloth only .
■ Never use sharp or abrasive cleaning agents
under any circumstances .
GB │ IE │ NI │ 11 ■